H3C Technologies H3C SecPath F1000-E User Manual
Page 763
17
Figure 32 Add a GRE over IPv4 tunnel interface (Tunnel 1)
•
Type 1 in the Tunnel Interface text box.
•
Type IP address/mask 192.168.22.2/24.
•
Select Management from the Zone drop-down list. (Select a security zone according to your
network configuration.)
•
Type the tunnel source IP address 10.1.1.2.
•
Type the tunnel destination IP address 10.1.1.1.
•
Click Apply.
# Configure a static route from Device B through interface Tunnel 0 to the branch network.
•
Select Network > Routing Management > Static Routing from the navigation tree and
then click Add to perform the configurations shown in
.
Figure 33 Add a static route from Device B through interface Tunnel 0 to the branch network
•
Type 192.168.12.0 as the destination IP address.
•
Select mask 255.255.255.0.