H3C Technologies H3C SecPath F1000-E - Manual (Page 920)

55
• Type the link name ISP1.
• Type the next hop 202.0.0.1.
• Click Apply.
# Create the physical link corresponding to ISP 2.
• Click Add on the Physical Link tab page to perform the following configurations, as shown in
Figure 62 .
• Type the link name ISP2.
• Type the next hop 100.0.0.1.
• Click Apply.
# Enable DNS redirection.
• Select High Reliability > Load Balance > Link Load Balance > Inbound from the
navigation tree, and perform the following configurations in the Inbound area, as shown in
Figure
63 .
Figure 63 Enable DNS redirection
Select the Enable DNS Redirection check box.
• Click Apply.
# Create the DNS entry corresponding to ISP 1.
• Click Add in the DNS Table area to perform the following configurations, as shown in Figure 64 .