H3C Technologies H3C SecPath F1000-E - Manual (Page 150)

3
Item Description
Port Number
Set the port number for HTTP service.
You can view this configuration item by clicking the expanding button in
front of HTTP.
IMPORTANT:
When you modify a port, ensure that the port is not used by other service.
ACL
Associate the HTTP service with an ACL. Only the clients that pass the ACL
filtering are permitted to use the HTTP service.
You can view this configuration item by clicking the expanding button in
front of HTTP.
Enable HTTPS
service Specify whether to enable the HTTPS service.
The HTTPS service is disabled by default.
Port Number
Set the port number for HTTPS service.
You can view this configuration item by clicking the expanding button in
front of HTTPS.
IMPORTANT:
When you modify a port, ensure that the port is not used by other service.
ACL
Associate the HTTPS service with an ACL. Only the clients that pass the ACL
filtering are permitted to use the HTTPS service.
You can view this configuration item by clicking the expanding button in
front of HTTPS.
HTTPS
PKI Domain
Set the PKI domain for the HTTPS service.
You can configure the available PKI domains by selecting VPN > PKI >
Domain from the navigation tree at the left side of the interface. For more
information, see PKI Configuration.
Service Management Configuration Examples
HTTP Configuration Example
Network requirements
As shown in Figure 2 , Host A resides on 192.168.1.0/24 and connects to Device through GigabitEthernet
0/1. It is required to
• Always allow Host A to access Device using HTTP.
• Allow other hosts to access Device using HTTP only on working days.