H3C Technologies H3C SecPath F1000-E - Manual (Page 765)

19
Figure 35 Add a GRE over IPv4 tunnel interface (Tunnel 1)
• Type 1 in the Tunnel Interface text box.
• Type IP address/mask 172.168.2.3/24.
• Select Management from the Zone drop-down list. (Select a security zone according to your
network configuration.)
• Type the tunnel source IP address 11.1.1.3.
• Type the tunnel destination IP address 11.1.1.2.
• Click Apply.
# Configure a static route from Device C through interface Tunnel 0 to the headquarters node, with the
routing priority being 1.
• Select Network > Routing Management > Static Routing from the navigation tree and
then click Add to perform the configurations shown in
Figure 36 .
Figure 36 Add a static route from Device C through interface Tunnel 0 to the headquarters node