Verification – H3C Technologies H3C SecPath F1000-E User Manual
Page 745
9
•
Click Apply.
Step2
Configure Device B. (The configuration pages of Device B are similar to those of Device A. See the
figures provided for configurations on Device A.)
# Configure an IPv4 address and assign the interfaces to security zones (omitted).
# Create a GRE tunnel interface.
•
Select VPN > GRE > GRE from the navigation tree and then click Add.
•
Type 0 in the Tunnel Interface text box.
•
Type IP address/mask 10.1.2.2/24.
•
Select Trust from the Zone drop-down list. (Select a security zone according to your network
configuration.)
•
Type the source end IP address 2.2.2.2, the IP address of GigabitEthernet 0/1.
•
Type the destination end IP address 1.1.1.1, the IP address of GigabitEthernet 0/1 on Device A.
•
Click Apply.
# Configure a static route from Device B through interface Tunnel 0 to Group 1.
•
Select Network > Routing Management > Static Routing from the navigation tree and
then click Add.
•
Type 10.1.1.0 as the destination IP address.
•
Select mask 255.255.255.0.
•
Select Tunnel0 as the outbound interface.
•
Click Apply.
Verification
# After the above configurations, log in to the Web interface of Device A and then select Device
Management > Interface from the navigation tree. Click the name link of Tunnel0. You can view
the status of interface Tunnel0, as shown in
.