H3C Technologies H3C SecPath F1000-E - Manual (Page 3)

2
Figure 2 Login page of the Web interface
NOTE:
•
The PC where you configure the device is not necessarily the Web-based network management
terminal. A Web-based network management terminal is a PC (or another terminal) used to log in to the
Web interface and is required to be reachable to the device.
• After logging in to the Web interface, you can create a new user and configure the IP address of the
interface connecting the user and the device.
• If you click the verification code displayed on the Web login page, you can get a new verification code.
• Up to five users can concurrently log in to the device through the Web interface.
Saving the Current Configuration
Select Device Management > Maintenance from the navigation tree to enter the saving
configuration page. Click Apply to save the current configuration of the device.
Note the following when saving configuration:
• Configuration saving takes a period of time.
• The system does not support two or more users to save configuration simultaneously. If such a case
occurs, the system will prompt the latter users to try again later.
Logging Out of the Web Interface
Click Logout in the upper-right corner of the Web interface to quit Web-based network management.
The system will not save the current configuration before you log out of the Web interface. Therefore, it is
recommended to save the current configuration before logout.
Introduction to the Web Interface
The Web interface is composed of three parts: navigation tree, title area, and body area, as shown in
Figure 3 .