Network requirements, Configuration procedure – H3C Technologies H3C SecPath F1000-E User Manual
Page 119
29
Figure 33 Create a Layer 3 static aggregation group on Device B
Layer 3 Dynamic Link Aggregation Configuration Example
Network requirements
As shown in
:
•
Device A and Device B are connected by their Layer 3 Ethernet interfaces GigabitEthernet 1/1
through GigabitEthernet 1/2.
•
Configure a Layer 3 dynamic link aggregation group on Device A and Device B respectively to
enable communication between both ends.
Figure 34 Network diagram for Layer 3 dynamic link aggregation
Configuration procedure
Step1
Configure LACP priorities on Device A, as shown in Figure 35.
•
Select Device Management > LACP from the navigation tree.
•
Type the port aggregation priority as 1.
•
Select the interfaces GigabitEthernet 1/1 and GigabitEthernet 1/2.
•
Type the system LACP priority as 2.
•
Click Apply.