H3C Technologies H3C SecPath F1000-E - Manual (Page 261)

4
Table 1 Static name resolution table configuration task list
Task Remarks
Configuring Static Name Resolution
Entries
Required
Configure static domain name resolution entries, that is, mappings
between host name and IP address.
By default, no static domain name resolution entry is created.
You can configure up to 50 static domain name resolution entries.
Configuring dynamic domain name resolution
Perform the tasks in Table 2 to configure dynamic domain name resolution.
Table 2 Dynamic domain name resolution configuration task list
Task Remarks
Configuring Dynamic Domain Name Resolution
Required
Enable dynamic domain name resolution.
This function is disabled by default.
Configuring DNS Server Addresses
Required
Not configured by default.
You can configure up to six domain name servers.
Configuring Domain Name Suffixes
Optional
Not configured by default.
You can configure up to ten domain name suffixes.
Configuring DNS proxy
Perform the tasks in Table 3 to configure DNS proxy.
Table 3 DNS proxy configuration task list
Task Remarks
Configuring DNS Proxy
Required
Configure the device as a DNS proxy.
By default, the device is not a DNS proxy.
Configuring DNS Server Addresses
Required
Not configured by default.
You can configure up to six domain name servers.
Configuring Static Name Resolution Entries
Select Network > DNS > Static from the navigation tree to enter the static domain name resolution
configuration page, as shown in
Figure 3 . Click Add to enter the page shown in Figure 4 .