H3C Technologies H3C SecPath F1000-E User Manual
Page 756
10
# Configure a static route from Device A through interface Tunnel 0 to the branch network.
•
Select Network > Routing Management > Static Routing from the navigation tree and
then click Add to perform the configurations shown in
.
Figure 23 Add a static route from Device A through interface Tunnel 0 to the branch network
•
Type 192.168.12.0 as the destination IP address.
•
Select mask 255.255.255.0.
•
Select Tunnel0 as the outbound interface.
•
Click Apply.
Step2
Configure Device B
# Configure an IPv4 address for each interface and assign the interfaces to security zones (omitted).
# Create a GRE over IPv4 tunnel interface.
•
Select VPN > GRE > GRE from the navigation tree and then click Add to perform the
configurations shown in
.
Figure 24 Add a GRE over IPv4 tunnel interface