H3C Technologies H3C SecPath F1000-E - Manual (Page 661)

3
Figure 2 Enable protocol identification
The State Management column shows the current state indicator and operation button
corresponding to each security zone.
• After the protocol identification feature is enabled for a security zone, the corresponding indicator
and operation button appear to be
in the State Management column. You can
click Disable to disable the protocol identification feature for the security zone.
• After the protocol identification feature is disabled for a security zone, it’s the corresponding
indicator and operation button appear to be
in the State Management column.
You can click Enable to enable the protocol identification feature for the security zone.
Return to P2P traffic control configuration task list .
Configuring Protocol Groups
Select Identification > P2P Identify > Protocol Group from the navigation tree to enter the page
shown in
Figure 3 . Click Add to enter the page for creating a new protocol group, as shown in Figure
4 .
Figure 3 Configure protocol groups
Figure 4 Create a protocol group