Configuration guidelines – H3C Technologies H3C SecPath F1000-E User Manual
Page 462
21
Figure 22 Configure internal Web server 2
•
Select GigabitEthernet0/1 for Interface.
•
Select 6(TCP) for Protocol Type.
•
Click the radio button next to Assign IP Address, and then type 202.38.1.1 for Global IP.
•
Select the upper radio button next to Global Port and type 8080.
•
Type 10.110.10.2 in Internal IP.
•
Type 80 in Internal Port.
•
Click Apply.
Configuration Guidelines
When configuring address pools, note the following:
1.
Low-priority address pools cannot include addresses in non low-priority address pools, external IP
addresses for one-to-one NAT, and public addresses of internal servers.
2.
If 6(TCP) or 17(UDP) is not selected as the protocol type when configuring an internal server,
you can only configure the mapping between Internal IP and Global IP. In this case, the
Internal Port and Global Port options are not available.
3.
The address pool, dynamic NAT, static NAT, and internal server configurations can be modified
through Web pages. Note that the modification you make takes effect after the former
configuration is removed by the system.