H3C Technologies H3C SecPath F1000-E - Manual (Page 86)

7
• Select Device Management > Interface from the navigation tree, click the icon
corresponding to GigabitEthernet0/1, and make the following configurations, as shown in
Figure 6 .
Figure 6 Modify interface GigabitEthernet 0/1
• Select the Bridge mode option for the working mode item.
• Click Apply.
# Change the working mode of GigabitEthernet 0/2 into bridge. (The configuration here is the same as
that for GigabitEthernet 0/1)
# Create VLAN-interface 1. By default, VLAN 1 exists and all ports are untagged members of VLAN 1.
• On the interface management page, click Add, and make the following configurations, as shown
in Figure 7 .