H3C Technologies H3C SecPath F1000-E User Manual
Page 422
14
•
Select Extensible Protocol as the protocol type.
•
Select Standard as the RADIUS packet type.
•
Click OK.
# Add a user for device management.
From the navigation tree, select User Management > User for Device Management, and then
in the right pane, click Add to enter the Add Account window and perform the following
configurations, as shown in
:
Figure 9 Add an account for device management
•
Add a user named hello@bbb.
•
Specify the password as abc and confirm the password.
•
Select Telnet as the service type.
•
Set the EXEC privilege level to 3. This value identifies the privilege level of the Telnet user after login,
which is 0 by default.
•
Specify the IP address range of the hosts to be managed as 192.168.1.0 to 192.168.1.255, and click
Add.
•
Click OK to finish the operation.
When the RADIUS server runs iMC:
NOTE:
This example assumes that the RADIUS server runs iMC PLAT 3.20-R2602 and iMC UAM 3.60-E6102.
# Add an access device.
Log into the iMC management platform, select the Service tab, and select Access Service > Service
Configuration from the navigation tree to enter the Service Configuration page. Then, click Add
to enter the Add Access Device page and perform the following configurations, as shown in
: