H3C Technologies H3C SecPath F1000-E - Manual (Page 771)

25
Figure 44 Add a static route from Device B through interface Tunnel 0 to the headquarters node
• Type 172.17.17.0 as the destination IP address.
• Select mask 255.255.255.0.
• Select Tunnel0 as the outbound interface.
• Click Apply.
Step3 Configure Device C
# Configure an IPv4 address for each interface and assign the interfaces to security zones (omitted).
# Create a GRE over IPv4 tunnel interface.
• Select VPN > GRE > GRE from the navigation tree and then click Add to perform the
configurations shown in
Figure 45 .
Figure 45 Add a GRE over IPv4 tunnel interface
• Type 0 in the Tunnel Interface text box.
• Type IP address/mask 192.168.22.3/24.