Verification – H3C Technologies H3C SecPath F1000-E User Manual
Page 757
11
•
Type 0 in the Tunnel Interface text box.
•
Type IP address/mask 192.168.22.2/24.
•
Select Management from the Zone drop-down list. (Select a security zone according to your
network configuration.)
•
Select the tunnel source interface GigabitEthernet 0/1.
•
Type the tunnel destination IP address 11.1.1.1, the IP address of GigabitEthernet 0/1 on Device A.
•
Click Apply.
# Configure a static route from Device B through interface Tunnel 0 to the headquarters node.
•
Select Network > Routing Management > Static Routing from the navigation tree and
then click Add to perform the configurations shown in
.
Figure 25 Add a static route from Device B through interface Tunnel 0 to the headquarters node
•
Type 192.168.11.0 as the destination IP address.
•
Select mask 255.255.255.0.
•
Select Tunnel0 as the outbound interface.
•
Click Apply.
Verification
# On Device A, select VPN > GRE > P2MP from the navigation tree, and then click the Tunnel List
tab to view the tunnel entries. There should be no tunnel entry.
# Ping Host A from Host B. The ping operation succeeds.
# On Device A, click Refresh under the tunnel entry list. The P2MP GRE tunnel entry should have been
installed, as shown in
.