Configuration procedure, Figure 12 – H3C Technologies H3C SecPath F1000-E User Manual
Page 385
17
•
Device A connects to N1 through GigabitEthernet 0/1, and to Device C through GigabitEthernet
0/0.
•
Device B connects to N2 through GigabitEthernet 0/1, and to Device C through GigabitEthernet
0/0.
•
IGMPv2 is to run between Device A and N1, and between Device B and N2.
Figure 12 Network diagram for PIM-DM configuration
Ether
net
Ethe
rnet
Source
192.168.1.16/24
PIM-DM
Device A
Device B
Device C
Receiver
Host A
Host B
N1
GE0/1
192.168.2.1/24
GE0/1
192.168.3.1/24
GE0/0
192.168.1.1/24
GE0/2
10.1.2.1/24
GE0/1
10.1.1.1/24
Ether
net
Receiver
Host C
Host D
N2
GE0/0
10.1.2.2/24
GE0/0
10.1.1.2/24
Device Interface IP
address
Device Interface IP
address
Device A
GE0/0
10.1.1.2/24
Device C
GE0/0
192.168.1.1/24
GE0/1
192.168.2.1/24
GE0/1
10.1.1.1/24
Device
B
GE0/0 10.1.2.2/24
GE0/2 10.1.2.1/24
GE0/1
192.168.3.1/24
Configuration procedure
Step1
Configure IP addresses and unicast routing
Configure the IP address for each interface as per
and configure the security zone. Detailed
configuration steps are omitted here.
Configure the OSPF protocol for interoperation in the PIM-DM domain. Ensure the network-layer
interoperation in the PIM-DM domain and enable dynamic update of routing information through a
unicast routing protocol. Detailed configuration steps are omitted here.
Step2
Enable IP multicast routing, and enable PIM-DM and IGMP
# On Device A, enable IP multicast routing, enable PIM-DM on each interface, and enable IGMP on
GigabitEthernet 0/1, which connects to N1.
•
After logging into the Web interface of Device A, select Network > Routing Management >
Multicast Routing from the navigation tree to enter the Global Configuration page shown
in
.