H3C Technologies H3C SecPath F1000-E - Manual (Page 82)

3
Creating an Interface
Select Device Management > Interface from the navigation tree to enter the page shown in Figure
1 . Click Add to enter the page for creating interfaces, as shown in Figure 3 .
Figure 3 Create an interface
Table 1 describes the configuration items of creating an interface.
Table 1 Configuration items of creating an interface
Item Description
Interface Name
Set the name for the interface or its subinterface.
Select an interface type in the drop-down list:
• If you select logical interface, set the interface number in the box behind
• If you select physical interface, set the subinterface number in the box
behind).
VID
Set the VLAN ID associated with the subinterface.
This parameter is available only after you set the interface name for a
subinterface of a Layer 3 Ethernet interface in the previous step.
MTU
Set the maximum transmit unit (MTU) of the interface.
The MTU value affects fragmentation and reassembly of IP packets.
IMPORTANT:
Support for this configuration item depends on the type of the interface
being created