beautypg.com

H3C Technologies H3C SecPath F1000-E User Manual

Page 424

background image

16

Figure 11 Add an account for device management

Add a user named hello@bbb

Specify the password as abc and confirm the password

Select Telnet as the service type

Set the EXEC privilege level to 3. This value identifies the privilege level of the Telnet user after login,

which is 0 by default.

Click Add in the IP address list of managed devices, and then specify the IP address range of the

hosts to be managed as 10.1.1.0 to 10.1.1.255

Click OK to finish the operation.

NOTE:

The IP address range of the hosts to be managed must contain the IP address of the access device added.

Step2

Configure the device

# Configure the IP address and security zone of each interface. (Omitted)
# Configure the RADIUS authentication and accounting servers.
From the navigation tree, select User > RADIUS > Server Configuration. Perform the configurations
shown in

Figure 12

and

Figure 13

.

This manual is related to the following products: