H3C Technologies H3C SecPath F1000-E User Manual
Page 256
10
•
Type 10.1.1.1 for IP Address.
•
Click Apply.
# Enable the DHCP relay agent on GigabitEthernet 0/1.
•
In the Interface Config field, click the icon of GigabitEthernet 0/1 and perform the
following configuration, as shown in
.
Figure 27 Enable DHCP relay agent on interface GigabitEthernet 0/1
•
Click on the Enable radio button in the DHCP Relay field.
•
Select 1 for Server Group ID.
•
Click Apply.
NOTE:
•
Performing configuration on the DHCP server is also required to guarantee the client-server
communication via the DHCP relay agent. For the DHCP server configuration, refer to
.
•
Because the DHCP relay agent and server are on different subnets, you need to configure a static route
or dynamic routing protocol to make them reachable to each other.