H3C Technologies H3C SecPath F1000-E - Manual (Page 349)

Item Remarks
Matching Mode
Select a matching mode for the node.
• permit: If a packet satisfies all the criteria defined by the if-match clauses,
the packet is permitted and the apply clauses are executed. Otherwise, the
packet will go to the next policy node for a match.
• deny: When a packet satisfies all the criteria defined by if-match clauses
on the policy node, the packet is rejected and will not go to the next policy
node.
Minimum Length
Maximum Length
Define an IP packet length match criterion
IMPORTANT:
To create a packet length match criterion, both the minimum and maximum
packet lengths must be set. Leaving either of the text boxes blank will delete the
match criterion.
Matched ACL Type an ACL number
Preference
Type an IP packet preference.
There are totally eight (in the range 0 to 7) preference levels, as shown in
Table
2 .
Next Hop Type the nexthop IP address
Default Next Hop Type the default nexthop IP address
Outbound Interface Type the outbound interface, which is available for P2P links only
Default Outbound
Interface
Type the default outbound interface, which is available for P2P links only
Table 2 IP preference values and keywords
Preference value Keyword
0 routine
1 priority
2 immediate
3 flash
4 flash-override
5 critical
6 internet
7 network
Applying a Policy
Select Network > Routing Management > Policy Routing from the navigation tree, and then
click the Application tab to enter the page shown in
Figure 3 . Click Add to enter the page where you
can apply a policy, as shown in Figure 4 .