H3C Technologies H3C SecPath F1000-E - Manual (Page 139)

5
Return to Virtual device configuration task list .
Selecting a Virtual Device
Select Device Management > Virtual Device > Device Selection from the navigation tree to
enter the virtual device selection page, as shown in
Figure 5 .
Figure 5 Selecting a virtual device
Select the intended virtual device in the Operation column, and the system prompts you for
confirmation, as shown in
Figure 6 .
Figure 6 Selected virtual device
Virtual device configuration task list shows the recommended virtual device configuration steps.
Virtual Device Configuration Example
Network requirements
Divide Device into two virtual devices and rent them to customer A and customer B respectively.
• Layer 3 networking: Customer A and customer B have their own Layer 3 Ethernet interfaces.
• Layer 2 networking: Customer A can use VLAN 100 through VLAN 205 and VLAN 300 through
VLAN 310; customer B can use VLAN 50 through VLAN 80, VLAN 400, and VLAN 500 through
VLAN 530.
• Create two virtual devices VD_A and VD_B.
• Add VLAN 100 through VLAN 205 and VLAN 300 through VLAN 310 to VD_A, and add VLAN
50 through VLAN 80, VLAN 400, and VLAN 500 through VLAN 530 to VD_B.
• Add Layer 3 Ethernet interface GigabitEthernet 0/1 to VD_A, and add Layer 3 Ethernet interface
GigabitEthernet 0/2 to VD_B.