H3C Technologies H3C SecPath F1000-E - Manual (Page 640)

5
Figure 6 Configure URPF in zoneB
• Select zoneB in Security Zone.
• Select Enable URPF.
• Select ACL and type 2010 in the text box.
• Select Strict in Type of Check.
• Click Apply.
2. Configure Device A
# Configure the interface IP addresses and security zones they belong to. (Omitted)
# Enable strict URPF check in zoneA.
• Select Intrusion Detection > URPF Check from the navigation tree and perform the following
operations, as shown in Figure 7 .
Figure 7 Configure URPF on zoneA
• Select zoneA in Security Zone.
• Select Enable URPF.
• Select Allow Default Route.
• Select Strict in Type of Check.