H3C Technologies H3C SecPath F1000-E - Manual (Page 252)

6
Table 5 DHCP server group configuration items
Item Description
Server Group ID
Type the ID of a DHCP server group.
You can create up to 20 DHCP server groups.
IP Address
Type the IP address of a server in the DHCP server group.
The server IP address cannot be on the same subnet as the IP address of the DHCP
relay agent; otherwise, the client cannot obtain an IP address.
Return to
DHCP Relay Agent Configuration Task List .
Enabling the DHCP Relay Agent on an Interface
Select Network > DHCP > DHCP Relay from the navigation tree to enter the page shown in Figure
19 . In the Interface Config field, the DHCP relay agent state of interfaces is displayed. Click the
icon next to a specific interface to enter the page shown in Figure 21 .
Figure 21 Configure a DHCP relay agent interface
Table 6 describes the DHCP relay agent interface configuration items.
Table 6 DHCP relay agent interface configuration items
Item Description
Interface Name This field displays the name of a specific interface.
DHCP Relay
Enable or disable the DHCP relay agent on the interface.
If the DHCP relay agent is disabled, the DHCP server is enabled on the interface.
Address Match
Check
Enable or disable IP address check.
With this function enabled, the DHCP relay agent checks whether a requesting client’s IP
and MAC addresses match a binding (dynamic or static) on the DHCP relay agent. If not,
the client cannot access outside networks via the DHCP relay agent. This prevents invalid
IP address configuration.
Server Group ID
Correlate the interface with a DHCP server group.
A DHCP server group can be correlated with multiple interfaces.
Return to
DHCP Relay Agent Configuration Task List .