H3C Technologies H3C SecPath F1000-E - Manual (Page 104)

14
Task Remarks
Creating a Layer 3 Static Aggregation Group
Assign one interface or multiple interfaces to the
aggregation group
Required
NOTE:
z You can assign only Layer 3 interfaces to a Layer
3 aggregation group.
z The two steps are simultaneously completed on
the Setup tab.
Creating a Layer 3 Static Aggregation Group
Select Device Management > Route Aggregation from the navigation tree to enter the page as
shown in
Figure 13 .
Figure 13 The Setup tab for Layer 3 static aggregation group configuration
Type the aggregation group ID, select the Static option, select one interface or multiple interfaces from
the interface list, and click Apply. The Summary tab appears, as shown in
Figure 14 .