H3C Technologies H3C SecPath F1000-E - Manual (Page 933)

11
Severity level Description Value
Debug
Information generated during
debugging
7
Note: A smaller value represents a higher severity level.
Displaying Connection Limit Logs
Select Log Report > Report > Connection Limit Log from the navigation tree to enter the page as
shown in Figure 8 .
Figure 8 Connection limit log configuration page
Table 10 describes the connection limit log configuration items.
Table 10 Connection limit log configuration items
Item Description
Time/Date Displays the time when the connection limit logs are generated.
Type
Displays the types of the traffic alarms: The number of source IP-based connections
exceeds the upper limit or the number of destination IP-based connections exceeds
the upper limit.
Source Zone Displays the source zone of the connection.
Source IP Displays the source IP address of the connection.
Destination Zone Displays the destination zone of the connection.
Destination IP Displays the destination IP address of the connection.
Current Rate Displays the rate of the current connection.
Current Connection Displays total number of the current connections.
TCP Percentage Displays the percentage of TCP packets to the total packets.
UDP Percentage Displays the percentage of UDP packets to the total packets.
ICMP Percentage Displays the percentage of ICMP packets to the total packets.