Layer 3 dynamic link aggregation configuration, Configuring lacp priorities – H3C Technologies H3C SecPath F1000-E User Manual
Page 106
16
Click the Remove tab to delete one aggregation group or multiple aggregation groups, as shown in
.
Figure 16 The Remove tab for Layer 3 static aggregation group configuration
Layer 3 Dynamic Link Aggregation Configuration
Layer 3 Dynamic Link Aggregation Configuration Task List
Complete the following tasks to configure Layer 3 dynamic link aggregation:
Task Remarks
Optional
By default, the port aggregation priority is 32768.
Creating a Layer 3 Dynamic Aggregation Group
Assign one interface or multiple interfaces to the
aggregation group
Required
NOTE:
z
You can assign only Layer 3 interfaces to a Layer
3 aggregation group.
z
The two steps are simultaneously completed on
the Setup tab.
Configuring LACP Priorities
Select Device Management > LACP from the navigation tree to enter the page as shown in
.