H3C Technologies H3C SecPath F1000-E - Manual (Page 498)

4
Creating a Static ARP Entry
Select Firewall > ARP Management > ARP Table from the navigation tree to enter the page
shown in
Figure 3 . Click Add to enter the New Static ARP Entry page, as shown in Figure 4 .
Figure 4 Add a static ARP entry
Table 1 describes the static ARP entry configuration items.
Table 1 Static ARP entry configuration items
Item Description
IP Address Type an IP address for the static ARP entry.
MAC Address Type a MAC address for the static ARP entry.
VLAN ID
Port
Type a VLAN ID and specify a port for the static ARP entry.
IMPORTANT:
The VLAN ID must be the ID of the VLAN that has already been created, and
the port must belong to the VLAN. The corresponding VLAN interface must
have been created.
Advanced
Options
VPN
Instance
Type the name of the VPN instance to which the static ARP entry belongs.
Static ARP Configuration Example
Network Requirements
As shown in Figure 5 , hosts are connected to the device, which is connected to the router through
GigabitEthernet 0/1 belonging to VLAN 10. The IP address of the router is 192.168.1.1/24. The MAC
address of the router is 00e0-fc01-0000.
To enhance communication security between the device and the router, a static ARP entry for the router
needs to be configured on the device.