H3C Technologies H3C SecPath F1000-E - Manual (Page 313)

18
Task Remarks
Import static routes
Configuring OSPF
Globally
Optional
Configure OSPF to redistribute static routes.
Configuring OSPF Areas
Required
Configure an OSPF area, specify the network
segment included in the area, so as to enable OSPF
on the interface attached to the specified network
segment.
Note:
This task allows you to configure one or more
interfaces in an area. You need to enable OSPF on
the interface whose primary IP address belongs to
the specified network segment; otherwise, OSPF
cannot run on the interface.
Configuring OSPF Interfaces
Optional
Configure timers and OSPF authentication
parameters on the OSPF interface.
Note:
To prevent leakage of routing information and guard
against attacks to OSPF routers, OSPF provides the
packet authentication function. To establish
neighboring relationship with a router, an OSPF
router sends packets containing the preconfigured
password for authentication. OSPF only receives
packets that pass authentication, so failed packets
cannot establish neighboring relationships.
Displaying OSPF Interface Information Optional
Displaying OSPF Neighbor Information Optional
Configuring OSPF Globally
Select Network > Routing Management > OSPF from the navigation tree to enter the OSPF
configuration page, as shown in Figure 20 .
Figure 20 OSPF global configuration page
Table 2 describes the OSPF global configuration items.