Verify the configuration – H3C Technologies H3C SecPath F1000-E User Manual
Page 158
11
Figure 15 Enable HTTPS service
•
Select the Enable HTTPS service check box.
•
Select PKI Domain 1.
•
Click Apply.
# Add a local user, set the password to 123, and service type to telnet.
Figure 16 Add a local user
•
Type the user name usera.
•
Select the user privilege level Configure.
•
Specify the service type as Telnet.
•
Type password 123 in two text boxes.
•
Click Apply to finish the operation.
Verify the configuration
Open an Internet browser on Host and type https://10.1.1.1 in the address bar to enter the Web login
interface. Type the username usera, password 123, and verification code, and then click Log in. You
can access the device.
This manual is related to the following products: