H3C Technologies H3C SecPath F1000-E - Manual (Page 46)

6
Table 3 Interface IP address configuration items
Item Description
IP Configuration
Set the approach for obtaining the IP address, including:
• None: The IP address of the interface is not specified,
that is, the interface has no IP address.
• Static Address: Specify the IP address for the interface
manually; if you select this item, you need to specify
both the IP address and the mask.
• DHCP: The interface obtains an IP address
automatically through the DHCP protocol.
• Do not change: The IP address of the interface does not
change.
IP Address
Mask
If you select Stack Address as the approach for
obtaining the IP address, you need to set the interface IP
address and network mask.
Modification to the
interface IP address
will result in
disconnection with the
device, so make
changes with caution.
Configuring NAT
Click Next on the interface IP address configuration page to enter the NAT configuration page, as
shown in
Figure 5 .
Figure 5 Basic configuration wizard: 5/6 (NAT configuration)