H3C Technologies H3C SecPath F1000-E - Manual (Page 60)

3
Figure 4 IPsec VPN policy configuration wizard: 2/4 (center node)
Step2 Configure the items on the page. Table 1 describes the configuration items.
Table 1 Configuration items on a center node: 2/4
Item Description
IPSec VPN Name
Type the name for the IPsec VPN.
IMPORTANT:
If you type abc here, the wizard will create an IKE peer named abc_peer, an
IPsec proposal named abc_prop, an IPsec template named abc_temp and
numbered 1, an IPsec policy named abc_poli and numbered 1, and an IKE
proposal numbered 10. The IKE peer and IPsec proposal will be referenced
in the IPsec template, and the template will be referenced in the IPsec policy.
IPSec Interface Select the interface to which you want to apply the IPsec policy.
Branch Gateway Name
Type the name of the remote gateway at the branch node, which will be used
during IKE negotiation.
Local IP
Address
Identity
Configuration
Local
Gateway
Name
Specify the ID type of the local end for IKE negotiation phase 1, which can be
one of the following:
• Local IP address – Uses the IP address of the local gateway as the ID. If you
do not specify the IP address, the default (the primary IP address of the
interface using the security policy) is used.
• Local gateway name – Uses the name of the local gateway as the ID. If you
do not specify the gateway name, the default (the device name) is used.
Step3 Click Next to enter the next page, as shown in Figure 5 .