H3C Technologies H3C SecPath F1000-E - Manual (Page 85)

6
Item Description
Interface Status
Display and set the interface status:
• If this item shows as Connected, indicating that the current
interface is up and connected, you can click the Disable button to
shut down the interface.
• If this item shows as Not connected, indicating that the current
interface is up but not connected, you can click the Disable button
to shut down the interface.
• If this item shows as Administratively Down, indicating that
the current interface is shut down by a network administrator, you
can click the Enable button to bring up the interface.
After you click the Enable/Disable button, the page displaying
interface information appears automatically.
IMPORTANT:
For an interface whose status cannot be changed, the
Enable/Disable button is not available.
Working Mode
Set the interface to work in bridge mode or router mode.
A loopback interface operates only in router mode.
Before configuring an IP address for the interface, make sure the
interface is configured to work in router mode.
Interface Management Configuration Example
Network requirements
As shown in Figure 5 , Device connects Host A and Host B through its interfaces GigabitEthernet 0/1 and
GigabitEthernet 0/2 respectively. Configure the two interfaces as shown in Figure 5 , so that both Host A
and Host B can access Device. Then, shut down GigabitEthernet 0/1 so that Host A will not be able to
access Device.
Figure 5 Network diagram for interface management
Device
Vlan-int1
GE0/2
1.1.2.1/24
Vlan-int1
GE0/1
1.1.2.1/24
Host A
Host B
Configuration procedure
# Change the working mode of GigabitEthernet 0/1 into bridge.