H3C Technologies H3C SecPath F1000-E - Manual (Page 823)

15
Table 5 Configuration items for adding an IP address pool
Item Description
ISP Domain Select the ISP domain for the IP address pool to be created.
IP Address Pool Number
Specify the number of the IP address pool.
If you set the IP address pool number to 1, the name of the IP address pool is
pool1.
Start IP
End IP
Specify the start IP address and end IP address of the IP address pool.
The number of addresses between the start IP address and end IP address
must not exceed 1024. If you specify only the start IP address, the IP address
pool will contain only one IP address, namely, the start IP address.
Return to
L2TP configuration task list .
Displaying L2TP Tunnel Information
Select VPN > L2TP > Tunnel Info from the navigation tree to enter the L2TP tunnel information page,
as shown in Figure 12 .
Figure 12 L2TP tunnel information
Table 6 describes the L2TP tunnel information in details.
Table 6 L2TP tunnel information
Item Description
Local Tunnel ID Local ID of the tunnel
Peer Tunnel ID Peer ID of the tunnel
Peer Tunnel Port Peer port of the tunnel
Peer Tunnel IP Peer IP address of the tunnel
Session Count Number of sessions on the tunnel
Peer Tunnel Name Peer name of the tunnel
Return to
L2TP configuration task list .