H3C Technologies H3C SecPath F1000-E - Manual (Page 265)

8
Domain Name Resolution Configuration Examples
Dynamic Domain Name Resolution Configuration Example
Network requirements
• The IP address of the DNS server is 2.1.1.2/16 and the domain name suffix is com.
• Device serving as a DNS client uses dynamic domain name resolution to access the host with the
domain name host.com and the IP address 3.1.1.1/16, as shown in
Figure 8 .
Figure 8 Network diagram for dynamic domain name resolution
Configuration procedure
NOTE:
• Before performing the following configuration, make sure that the device and the host are reachable to
each other, and related configurations are done on both the device and the host. For the IP addresses
of the interfaces, see Figure 8 .
• This configuration may vary with different DNS servers. The following configuration is performed on a
PC running Windows server 2000.
Step1 Configure the DNS server
# Enter the DNS server configuration page.
Select Start > Programs > Administrative Tools > DNS.
# Create zone com.
As shown in
Figure 9 , right click Forward Lookup Zones, select New zone, and then follow the
instructions to create a new zone named com.