H3C Technologies H3C SecPath F1000-E - Manual (Page 45)

5
Item Description
HTTPS
Specify whether to enable HTTPS on the device, and set the HTTPS port number.
Disabled by default.
IMPORTANT:
z If the current user logged in to the web interface through HTTPS, disabling
HTTPS or modifying the HTTPS port number will result in disconnection with
the device; therefore, perform the operation with caution.
z When you modify a port number, ensure that the port number is not used by
another service.
z By default, HTTPS uses the PKI domain default. If this PKI domain does not
exist, the system will prompt you for it when the configuration wizard is
completed; however, this will not affect the execution of other configurations.
Configuring the IP Address for an Interface
Click Next on the service management configuration page to enter the interface IP address
configuration page, as shown in
Figure 4 . The table lists the IP address configuration information for all
Layer 3 Ethernet interfaces and VLAN interfaces. You can click a value in the table and then modify it.
Figure 4 Basic configuration wizard: 4/6 (interface IP address configuration)
Table 3 describes the interface IP address configuration items.