H3C Technologies H3C SecPath F1000-E - Manual (Page 472)

9
Figure 13 Configure an ACL rule to permit packets sourced from 192.168.1.0/24
• Select Permit as the operation.
• Select the Source IP Address check box, type192.168.1.0 as the source IP address, and type
0.0.0.255 as the source wildcard.
• Click Apply.
• Click Add. Create an ACL rule as shown in Figure 14 .
Figure 14 Configure an ACL rule to deny packets
• Select Deny as the operation.
• Click Apply.
Step3 Configure dynamic NAT.
# Configure the address pool.
• Select Firewall > NAT Policy > Dynamic NAT from the navigation tree. In the Address Pool
area, click Add. Add a NAT address pool as shown in
Figure 15 .