H3C Technologies H3C SecPath F1000-E - Manual (Page 350)

Figure 3 PBR application page
Figure 4 Apply a policy
Table 3 describes the policy application configuration items.
Table 3 Policy application configuration items:
Item Remarks
Apply to
Specify the policy application mode:
• Local: Enable local PBR. Unless otherwise
required, you are not recommended to enable
local PBR.
• Interface: Enable interface PBR. Apply the policy
on a selected interface.
Policy Name Type the name of the policy to be applied.
PBR Configuration Example
Network requirements
As shown in Figure 5 , configure PBR based on policy aaa to send TCP packets received from
GigabitEthernet 0/1 through GigabitEthernet 0/2. Non-TCP packets are forwarded based on the
routing table.