H3C Technologies H3C SecPath F1000-E - Manual (Page 489)

11
Item Description
Destination Wildcard
MAC address and wildcard.
LSAP Type
LSAP Wildcard
Select the LSAP Type check box and specify the DSAP and SSAP fields in the
LLC encapsulation by configuring the following two items:
• LSAP Type: Indicates the frame encapsulation format.
• LSAP Wildcard: Indicates the LSAP wildcard.
Protocol Type
Protocol Wildcard
Select the Protocol Type check box and specify the link layer protocol by
configuring the following two items:
• Protocol Type: Indicates the frame type. It corresponds to the type-code
field in Ethernet_II and Ethernet_SNAP frames.
• Protocol Wildcard: Indicates the wildcard.
Return to
ACL configuration task list .
Configuring ACL Acceleration
Select Firewall > ACL from the navigation tree to enter the page shown in Figure 1 . All existing ACLs
will be displayed in the right pane. You can enable or disable ACL acceleration for an ACL through the
ACL Acceleration column:
• indicates that the ACL is not accelerated. You can click the Start
Accelerating link to enable ACL acceleration.
• indicates that the ACL is accelerated. You can click the Stop Accelerating
link to disable ACL acceleration.
• indicates that the ACL has been modified after it was configured with ACL
acceleration. You can click the Start Accelerating link to enable ACL acceleration again,
making changes to the ACL take effect.
Return to ACL configuration task list .
ACL Configuration Example
Network requirements
As shown in Figure 9 , Host A connects to Device through GigabitEthernet 0/1. Configure an ACL to:
• Allow Host A to access Device using HTTP.
• Allow hosts on other segments to access Device using HTTP on only working days.