H3C Technologies H3C SecPath F1000-E - Manual (Page 290)

5
Configuring RIP Basic Functions
Configuration Prerequisites
Before configuring RIP basic functions, complete the following tasks.
• Configure the link layer protocol.
• Configure an IP address on each interface, and make sure all adjacent routers are reachable to
each other.
Configuration Overview
Perform the tasks in Table 1 to configure RIP.
Table 1 RIP configuration task list
Task Remarks
Enable RIP Configuring RIP Globally
Required
Enable RIP on all interfaces.
Import static routes Configuring RIP Globally
Optional
Configure RIP to redistribute static routes.
Configuring Interface RIP
Optional
Configure the Work State, Version, and
Authentication Mode for RIP interfaces.
Configuring RIP Globally
Select Network > Routing Management > RIP from the navigation tree to enter the RIP
configuration page, as shown in
Figure 4 .
Figure 4 RIP global configuration page
Table 2 describes the RIP global configuration items.
Table 2 RIP global configuration items
Item Description
Enable RIP (enable all interfaces automatically) Enable RIP on all interfaces.
Import static routes Configure RIP to redistribute static routes.