H3C Technologies H3C SecPath F1000-E - Manual (Page 582)

4
Figure 10 Add a static address mapping
• Type 1.1.1.1 for Internal IP Address.
• Type 2.2.2.3 for Global IP Address.
• Click Apply.
# Enable static NAT on GigabitEthernet 0/1.
• In the Interface Static Translation area, click Add to perform configurations shown in Figure
11 .
Figure 11 Enable static NAT on an interface
• Select interface GigabitEthernet0/1.
• Click Apply.
# Configure virtual fragment reassembly.
• Select Firewall > Session Table > Advanced from the navigation tree to perform
configurations shown in
Figure 12 .