Configuration guidelines – H3C Technologies H3C SecPath F1000-E User Manual
Page 401
11
Figure 15 Display the port statistics of GigabitEthernet 0/1
Configuration Guidelines
•
VLAN 1 is the default VLAN, which can be neither created nor removed manually.
•
Some VLANs are reserved for special purposes. You can neither create nor remove them manually.
•
You cannot manually remove dynamic VLANs.
•
You are recommended to set the same default VLAN ID for the local and remote ports.
•
Ensure that a port is assigned to its default VLAN. Otherwise, when the port receives frames tagged
with the PVID tag or untagged frames (including protocol packets such as STP BPDUs), the port
filters out these frames.
•
As shown in
, on the VLAN configuration page, when you type a VLAN range in the VLAN
Range box and then click Select, the table below lists the information about all the VLANs within
this range, which makes the operation much easier when the device contains a large number of
VLANs; after you click Delete, all VLANs within this range will be removed.