H3C Technologies H3C SecPath F1000-E - Manual (Page 448)

7
Figure 4 Dynamic NAT configuration page
Figure 5 Add NAT Address Pool page
Table 4 describes the NAT address pool configuration items.
Table 4 NAT address pool configuration items
Item Description
Index Specify the index of an address pool.
Start IP Address Specify the start IP address of the address pool.
End IP Address
Specify the end IP address of the address pool.
The end IP address must be identical to or higher than the start IP address.
Low priority
Configure the address pool as a low-priority or a non low-priority address pool.
IMPORTANT:
This configuration item is applicable to the stateful failover networking only. You
cannot configure the same address pool as the low-priority address pool on the local
and peer devices.