H3C Technologies H3C SecPath F1000-E - Manual (Page 559)

4
Figure 3 Create a CAR list
Table 2 describes the configuration items of creating a CAR list.
Table 2 Configuration items of creating a CAR list
Item Description
CAR List Index Specify the CAR list index.
IP Type
Select to configure a source IP-based CAR list or
destination IP-based CAR list.
IP Set
Define the way of specifying a set of IP addresses.
Two options are available:
• Subnet: Specifies a network segment by specifying
an IP address and a subnet mask.
• IP Range: Specifies an IP address range by
specifying a start IP address and an end IP
address.
IP Address
Mask
Specify an IP address and a subnet mask.
The two items are available when you select Subnet
from the IP Set drop-down list.
Start IP Address
End IP Address
Specify a start IP address and an end IP address.
The two items are available when you select IP
Range from the IP Set drop-down list.
Limit Rate Per IP Address
Specify to perform per-IP address rate limiting.
With this function enabled, rate limiting is performed
for traffic of each IP address in the specified IP address
set separately. Otherwise, rate limiting is performed
for all traffic of the IP address set.