Configuration procedure, Verify the configuration, N in – H3C Technologies H3C SecPath F1000-E User Manual
Page 293: Figure 7
8
Figure 7 Network diagram for RIP configuration
Configuration procedure
Step1
Configure an IP address for each interface and configure security zones (Omitted)
Step2
Enable RIP
# Configure Device A.
•
Select Network > Routing Management > RIP from the navigation tree of Device A.
•
Select the Enable RIP(Enable all interfaces automatically) check box, as shown in
.
•
Click Apply.
Figure 8 Enable RIP
# Configure Device B.
•
Select Network > Routing Management > RIP from the navigation tree of Device B.
•
Select the Enable RIP(Enable all interfaces automatically) check box, as shown in
.
•
Click Apply.
Verify the configuration
# Display active routes of Device A.
Select Network > Routing Management > Routing Info from the navigation tree of Device A to
display learned RIP route destined for 10.0.0.0/8, as shown in
.