H3C Technologies H3C SecPath F1000-E - Manual (Page 613)

4
Configuration procedure
# Assign IP addresses to the interfaces. (Omitted)
# Enable the blacklist feature.
From the navigation tree, select Intrusion Detection > Blacklist to bring up the blacklist
management page and perform configuration as shown in Figure 4 .
Figure 4 Enable the blacklist feature
• In the Global Configuration area, select the Enable Blacklist option.
• Click Apply.
# Add a blacklist entry for Host D.
In the Blacklist Configuration area, click Add and then perform configurations as shown as shown
in Figure 5 .
Figure 5 Add a blacklist entry for Host D
• Enter IP address 5.5.5.5.
• Select the Permanence option.
• Click Apply to complete the configuration.
# Add a blacklist entry for Host C.
In the Blacklist Configuration area, click Add and then perform configurations as shown as shown
in Figure 6 .