H3C Technologies H3C SecPath F1000-E - Manual (Page 320)

25
Figure 27 Network diagram for OSPF
Area 0
Area 1
NSSA
Area 2
Device C
GE0/1
10.1.1.2/24
GE0/1
10.1.1.1/24
GE0/0
10.4.1.1/24
GE0/1
10.2.1.2/24
Device B
GE0/0
10.3.1.1/24
GE0/1
10.3.1.2/24
Device A
GE0/0
10.2.1.1/24
GE0/0
10.5.1.1/24 Device D
ASBR
Configuration procedure
Step1 Configure IP addresses for interfaces and configure security zones (omitted).
Step2 Configuring OSPF basic functions.
# Configure Device A.
• Select Network > Routing Management > OSPF from the navigation tree of Device A.
• Select the Enable OSPF check box, as shown in the following figure.
Figure 28 Enable OSPF
• Click Apply. After you enable OSPF, the following figure is displayed.