H3C Technologies H3C SecPath F1000-E - Manual (Page 854)

5
Item Description
Current Status
Current stateful failover state of the device, which can be:
• Silence: Indicates that the device has just started, or is transiting from
synchronization state to independence state.
• Independence: Indicates that the silence timer has expired, but no failover link
is established.
• Synchronization: Indicates that the device has completed state negotiation
with the other device and is ready for data backup.
Current Configuration
Synchronization Status
Displays the current configuration synchronization state, including:
• A configuration conflict occurs: Indicates both devices are active or standby
devices.
• Waiting for the synchronization status
• Preparing for synchronization
• Synchronizing all configurations
• Synchronizes configurations automatically: The synchronization of all
configurations has completed. Because auto synchronization is specified,
configuration updates on the active device will be automatically synchronized
to the standby device.
• Auto synchronization is not performed: The synchronization of all
configurations has completed. Because auto synchronization is not specified,
configuration updates on the active device will not be automatically
synchronized to the standby device. You can only manually synchronize
configurations by clicking the Manual Synchronization button.
Effective Backup Interface Displays the currently effective failover interface(s).
Enabling/Disabling Stateful Failover Version
Check
By default, stateful failover version check is enabled on the device. During device software upgrade, if
the software versions on the two devices are inconsistent, the network service can be interrupted. To
avoid such cases, execute the dhbk ignore-version-check command in system view at the
command line interface (CLI) on both devices.
Use the dhbk ignore-version-check command to disable the checking of the versions of the two
stateful failover devices. Use the undo dhbk ignore-version-check command to enable the
checking of the versions of the two stateful failover devices.
NOTE:
The dhbk ignore-version-check command applies to only version F3169 of F1000-E and version F3207
of F5000-A5.