Inline layer 2 forwarding configuration examples, Network requirements, Configuration procedure – H3C Technologies H3C SecPath F1000-E User Manual
Page 224
2
describes the configuration items for creating a Layer 2 inline forwarding policy.
Table 1 Configuration items for creating a Layer 2 inline forwarding policy
Item Description
Policy ID
Set the ID for identifying an inline forwarding policy
Policy Type
Select the inline forwarding type, which can be forward, blackhole, or reflect.
Port 1
Assign a port to the inline forwarding policy.
Port 2
Assign a port to the inline forwarding policy.
This option is available when the forwarding type is Forward.
Inline Layer 2 Forwarding Configuration Examples
Forward-Type Inline Forwarding Configuration Example
Network requirements
Packets received on GigabitEthernet 0/1 need to be forwarded from GigabitEthernet 0/2, and packets
received on GigabitEthernet 0/2 need to be forwarded from GigabitEthernet 0/1. In this case, you can
configure forward-type inline forwarding between GigabitEthernet 0/1 and GigabitEthernet 0/2.
Configuration procedure
NOTE:
Before configuration, make sure the GigabitEthernet 0/1 and GigabitEthernet 0/2 work in bridge mode
and they are added to zones.
# Create a forward-type inline forwarding policy.
•
Select Network > Forwarding in the navigation tree. Click Add to enter the page for adding
an inline forwarding policy. Perfrom the configuration as shown in
.
Figure 3 Add a forward-type inline forwarding policy
•
Type policy ID 1.
•
Select Forward as the policy type.
•
Select GigabitEthernet0/1 from the Port 1 drop-down list.