H3C Technologies H3C SecPath F1000-E - Manual (Page 416)

8
Item Description
Primary Server IP
IP address of the primary server
If no primary server is specified, the text box displays 0.0.0.0.
If you enter 0.0.0.0, it means that the previously configured primary server is
to be removed.
The IP address of the primary server cannot be the same as that of the
secondary server.
Primary Server UDP Port
UDP port of the primary server
Before you specify the IP address of the primary server or after you remove
the primary server IP address, the port number is 1812 for authentication or
1813 for accounting.
As RADIUS uses different UDP ports for authentication and accounting, you
need to specify different UDP ports for the two functions.
Primary Server Status
Status of the primary server, including:
• Active: The server is working normally.
• Blocked: The server is down.
Before you specify the IP address of the primary server or after you remove
the primary server IP address, the status is blocked.
Secondary Server IP
IP address of the secondary server
If no secondary server is specified, the text box displays 0.0.0.0.
If you enter 0.0.0.0, it means to remove the previously configured primary
server.
The IP address of the secondary server cannot be the same as that of the
primary server.
Secondary Server UDP Port
UDP port of the secondary server
Before you specify the IP address of the primary server or after you remove
the primary server IP address, the port number is 1812 for authentication or
1813 for accounting.
As RADIUS uses different UDP ports for authentication and accounting, you
need to specify different UDP ports for the two functions.
Secondary Server Status
Status of the secondary server, including:
• Active: The server is working normally.
• Blocked: The server is down.
If the IP address of the secondary server is not specified or the specified IP
address is to be removed, the status is blocked.
Return to
RADIUS configuration steps .
Configuring RADIUS Parameters
From the navigation tree, select User > RADIUS > Parameter Configuration to enter the RADIUS
parameter configuration interface, as shown in
Figure 6 .