H3C Technologies H3C SecPath F1000-E User Manual
Page 218
25
Figure 13 Configure global MSTP parameters on Device A
•
•
Select Enable in the Enable STP Globally drop-down list.
•
Select MSTP in the Mode drop-down list.
•
Select the check box in front of Instance.
•
Set the Instance ID field to 1.
•
Set the Root Type field to Primary.
•
Click Apply.
Step3
Configure Device B.
# Enter MST region view, configure the MST region name as example, map VLAN 10, VLAN 30, and
VLAN 40 to MSTI 1, MSTI 3, and MSTI 4 respectively, and configure the revision level of the MST region
as 0. (The procedure here is the same as that of configuring an MST region on Device A.)
# Enable MSTP globally and configure the current device as the root bridge of MSTI 3.
•
Select Network > MSTP > Global from the navigation tree, and make the following
configurations on the page similar to that shown in
.
•
Select Enable in the Enable STP Globally drop-down list.